Panasonic KX-P6500 - Manual (Page 45)

Using the Printer in MS-DOS
2 Press
f
Enter] to start the installation.
The Fast Installation window is displayed.
Fast Installation
Destination; C:\P6500CPS
Port: LPT1
Hot Key: Ctrt-Alt-R
Display Mode: GRAPHIC
Add REPORT to Autoexec.bat;NO
Is above correct? j
Yes No
If you do not wish to install the Control Panel
software, press f Esc] to exit.
Destination;
This is the disk drive and directory onto which your
software will be installed.
Port:
The Parallel port to which your printer is connected.
Hot Key:
Combination of keys which displays the KX-P6500 Con­
trol Panel Reporter window { n®* P. 52).
Display Mode:
With GRAPHIC mode selected, the display will show
graphics along with text. With TEXT mode selected, the
graphics will not appear on the screen.
Add REPORT to Autoexec.bat:
If you want the Reporter to be loaded automatically
whenever the computer is started or AUTOEXE.BAT is
performed, select “Yes”. Otherwise select “No”.
• The above settings in the Fast Installation window can
also be changed after installation of the Control Panel
software.
^ If you do not wish to change any settings,
press [ Enter ] and go to step 12.
2 If you wish to change a setting, seiect “No”
and press [ Enter].
The Input Destination Path screen is displayed.
If you wish to install the Control Panel
software on another drive and/or directory,
type the letter of the drive and/or directory
name, then press [ EntVr]. Otherwise just
press [ Enter ].
If you wish to change the port, use ®/^Qto
select the desired port, and press [ Enter].
Otherwise just press [ Enter].
8
10
If you wish to change the hot key, press i CtrT]
+ [ Alfl + your desired key (A to Z), and press
[ Enter] . Otherwise just press [ Enter].
If you wish to change the display mode, use
[T]/CDto select the desired mode, and press
[ Enter]. Otherwise just press
f
Enter] .
If you wish to change the Add Report to
Autoexec.bat, use [ Tab ] to select “Yes”,
and press [ Enter]. Otherwise just press
[Enter].
= 5
a S'
11
If all the settings above are correct, press
[ Enter] to confirm.
• If you have made a mistake, select “No” by
using f Tab] , and press i^nter]. In this case,
you must perform steps 6~11 again.
12
The display will show the files being copied
from floppy disk to hard disk.
13
When the Control Panel software installation
is completed, the Complete Installation win­
dow is displayed.
D- O
O
? o
1 =
I ®
So
D W
(D ^
CO
o
€
D>
O
14
Press [ Enter] to exit.
45