Yamaha HTR-5835 - Manual (Page 34)

PLAYBACK
■ Listening to unprocessed input signals
In STRAIGHT mode, two channel stereo sources are
output from only the front left and right speakers. Multi­
channel sources are decoded straight into the appropriate
channels without any additional effect processing.
Press STRAIGHT (or press AMP to select the
AMP mode, then press STRAIGHT on the remote
control) to select STRAIGHT.
Selecting input modes
This unit comes with a variety of input jacks. Do the
following to select the type of input signals you want to
use.
1
Rotate INPUT to select the input source.
! AMP I STRAIGHT
Front panel Remote contro!
♦
STRAIGHT
Press STRAIGHT (EFFECT) (or STRAIGHT (ENT.) on
the remote control) again so that “STRAIGHT”
disappears from the display when you want to turn the
sound effect back on.
■ Virtual CINEMA DSP
Virtual CINEMA DSP allows you to enjoy the CINEMA
DSP programs without surround speakers. It creates
virtual speakers to reproduce the natural sound field.
If you set “SUR. LR” to NONE (see page 55), Virtual
CINEMA DSP activates automatically whenever you
select a CINEMA DSP sound field program.
Note
Virtual CINEMA DSP will not activate, even when “SUR. LR” is
set to NONE (see page .S.S) in the following cases:
-When MULTI CH INPUT is selected as the input sottrce.
-When headphones are connected to the PHONES jack.
Press INPUT MODE to select an input mode,
in most cases, use AUTO.
INPUT MOPE
♦
VCR V-AUX DW«8L , OVD TUNER CD
i“» I i IP“» »'“a I I “1“ ii“"i
Input source Input mode
AUTO Automatically selects input signals m
the following order:
1) Digital signals*
2) Analog signals
Selects only digital signals encoded in
DTS. If no DTS signals are input, no
sound is output.
Selects only analog signals. If no
analog signals are input, no sound is
output.
* If this unit detects a Dolby Digital or DTS signal, the
decoder automatically switches to the appropriate
decoder.
y
You can adjust the default input mode of this unit (see page 58).
DTS
ANALOG
30