Yamaha HTR-5835 - Manual (Page 65)

REMOTE CONTROL FEA TURES
Setting remote control codes
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input area. For a complete list of available remote
control codes, refer to “LIST OF REMOTE CONTROL
CODES” at the end of this manual.
The following table shows the default component
(Library; component category) and the remote control
code for each area.
Remote Control Code Default Settings
Input area
Component
category
(Library)
Manufacturer
Default
YAMAHA
code
CD CD YAMAHA 199
MDYD-R CD-R YAMAHA 499
TLTNER‘1 TLINER YAMAHA FIX
DVD DVD YAMAHA 699
DTMCBLV - - -
V-Al,rX - - -
VCR - - -
* i You can control this unit and other Yamaha tuners only.
* - You can only set TV remote control codes for the DTV/CBL
button.
Note
You may not he able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try’ to set other YAMAHA remote control code(s).
1
While holding down CODE SET, press an
input selector button to select the
component you want to set up.
rvvr if-rvifi-.i.
Note
You must press and hold CODE SET throughout this
procedure.
With CODE SET depressed, use the numeric
buttons to enter the four-digit remote control
code for the component to be used.
Refer to “LIST OF REMOTE CONTROL CODES”
at the end of this manual.
1^
f ; . | ;
. : X \/
G^'
r p
, a ' i
s i t
a a i
'm-i
I p
m
ii
lit
■
.... .
2 Z J
net C'f
1 I.
; '
( K
}■
; i T } ;■ V ¡5 ;
Notes
•
If the manufacturer of your eomponent has more than one code,
try each of them until you find the correct one.
• You can only assign one remote control code to each input
selector button.
61