Panasonic cq-dpg55len - Manual (Page 20)

RDS (Radio Data System) Reception
continued
For Seek Tuning, RDS Station Preset, Tuning in a RDS preset station, and Auto RDS
Station Preset, please refer to Radio Basics (Page 16 to page 17).
RDS seek tuning (PI seek)
The PI seek function may be used if an RDS station selected from the
memory is poor in receiving condition. Press the preset button again
for the station now tuned in to.
<Remote control operation>
20
PI
S E E H ; ^
PI Seek: If Best Station Research fails in selecting the best station,
the PI seek function operates to automatically tune in to the
same program.
Region (REG) Switching
(Use the remote controller for the following operation.)
Press and hold AF for more than 1 second in AF mode to alternately
select REG ON and REG OFF.
PEG OFF
ms ^ ^
Note:
If you wish to stay with the same program, keep REG ON. If you keep
REG OFF, there is a higher possibility of returning in to an AF station
in better receiving condition.
The relationship of the PI seek function with REG ON and REG OFF
is as described above.
Changing Display
• Press DISP to change the display as follows.
(Frequency display continues for only 3 seconds, returning to PS
display after that.)
PS display -^1 -----
Frequency display—
CT display
•(3 seconds)
Clock Time (CT) System
The CT (24-hour) system may not properly operate in areas where
RDS CT service is not available. Once CT service is received, the CT
system keeps operating. “NO CT” is displayed in areas where no CT
service is available.
Clock Display
Press DISP to indicate the clock display.
CQ-DPG55LEN