Panasonic cq-dpg55len - Manual (Page 31)

Operating Procedures Aim the remote controller toward the sensor of
the main unit.
General
Power
® PWR (Power Button)
Press PWR to switch on the power.
Press PWR again to switch off the power.
s________________________________________ >
Mode Selection
О
MODE (Mode Button)
Press MODE to switch the operation mode in the
following order.
Tuner ^ CD Player
^ (CD Changer Control)
___________ -___________J'
---------------------------------------------------------------------------------------------------------^
^
Volume
VVOLA (Volume Control Button)
Press “A” or “V” to increase or decrease vol-
. ume level.
''---------------------------------------------------------------------
Super High Definition Bass
О s * HDB Button
• Press (S • HDB) to be able to listen to
high-definition bass.
• Press the same button again to cancel.____
Attenuator
Ф ATT Button
• Press ATT to decrease volume to about 1/10
of the previous level.
• Press ATT again to cancel.
Changing Audio Modes
9 SEL (Select Button)
Press SEL to switch the audio control mode in
the following order.
Normal Mode # VOL ^ BAS4TRE4BAL# FAD
t__________________Mr
Bass and Treble
9 VVOLA (Volume Control Button)
Press SEL to select the BASS (TREBLE) mode.
Press “VOLA” or “VVOL” to increase or
decrease the bass (treble) response.
V_______________________________________ y
--------------------------------------------------------------------------------------------------- N,
Balance
ill VVOLA (Volume Control Button)
Press SEL to select the BALANCE mode. Press
“VOLA” or “VVOL” to shift the sound volume
to the right or left speakers.
'________________________________________________ _______ _______________^
■“ ■■ ~ -s
Fader
® VVOLA (Volume Control Button)
Press SEL to select the FADER mode. Press
“VOL A” or “VVOL” to shift the sound volume
to the front or rear speakers.
Sound Memory
(Only for Remote Control)
Changing Sound Memory
0 SDM (SDM Button)
Press SDM to switch the sound memory in the following order.
Initial ^ SOUND 0 ■►SOUND 1 ^ SOUND 2 ^ SOUND 3
t_______________________ *
Sound memory settings are as follows.
BAS TRE BAL FAD S»HDB
SOUND 0 (at Initial) 0 0 Center Center OFF
SOUND 1 (On expressways: recommended) +6 +3 Center Center OFF
SOUND 2 (Vocal emphasized) -6 -6 Center Center OFF
SOUND 3 (Bass emphasized) 0 +3 Center Center ON
Notes: Desired sound memory input:
• If SDM is pressed at SOUND 0,1, 2, or 3 after changing BAS, TRE, BAL, FAD, or S*HDB settings, the
selected condition is stored in the memory of “SOUND 0”.
• When “SOUND” is not displayed, press SDM to show current SOUND mode.
Mode change is valid only when “SOUND” is displayed.
CQ-DPG55LEN
31