Parts of the printer, Rear view), Head gap lever – Panasonic KX-P3123 User Manual
Page 13: Lf (form length) switch, Function switch, Q) on line/function indicator, Super quiet indicator, Power/paper out indicator
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Parts of the Printer
(Rear View)
Top cover
Paper support
(c^ P.22)
Tractors
( P. 22)
AC power cord \\
Head Gap Lever
Adjusts the gap between the platen and the
printhead. The lever moves in increments of
0.0028 inch {0.07 mm).
Serial No. Label
Nameplate
Position
Used for
1 or 2
Thinner sheets
3, 4, 5 and 6
Thick or multiple
sheets, envelopes
Paper Feed Selector
“ Q ” (Friction) Single sheets
and envelopes
“ |]]” (Tractor) Fanfold paper
Serial interface cover
Centronics parallel interface
connector (us* P. 14, 94)
Frame ground
terminal (
d
®“ P. 14)
LF (FORM LENGTH) switch
Pressing this switch advances the paper one
tine at a time. Holding this switch wilt
advance the paper continuously until the
switch is released. These functions are
active in the OFF LINE mode or when not
printing in the ON LINE mode._________
In the FUNCTION mode, pressing the
switch advances the column for the
FORM LENGTH on the control table.
FUNCTION switch
This switch allows you to enter and exit the
FUNCTION mode.
(Q) ON LINE/FUNCTION indicator
This indicator is lit when the printer is in the
ON LINE mode, and is out in the OFF LINE
mode. It blinks in the FUNCTION mode.
@ SUPER QUIET indicator
This indicator is lit when the printer is in the
SUPER QUIET mode.
@
POWER/PAPER OUT indicator
This indicator is lit when the power is on and
paper is installed. It blinks when paper is not
installed.
13