Panasonic 2-LINE PLAIN PAPER FAX KX-FPW111 - Manual (Page 99)

Error Messages
Reports
If your unit cannot send a fax, check the following.
—The number you dialed is correct.
—The other party’s machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the sending and journal
reports (p. 66, 67).
i
i Communication message
Error
code
Cause & Remedy |
COMMUNICATION ERROR 41-72
FF
•A transmission or reception error occurred. Try again or check
with the other party.
DOCUMENT JAMMED — •The document is jammed. Remove the jammed document
(p. 108).
ERROR-NOT YOUR UNIT 54, 59
70
•A transmission or reception error occurred because of a problem
with the other party’s fax machine. Check with the other party.
MEMORY FULL — •The document was not received due to memory being full.
NO DOCUMENT — •The document was not fed into the unit properly. Reinsert the
document and try again.
OTHER FAX NOT RESPOND •The other party’s fax machine was busy or ran out of recording
paper. Try again.
•The document was not fed properly. Reinsert the document and
try again.
•The other party’s fax machine rings too many times. To send a
fax manually, dial the number, confirm the fax tone, and press
(START/SET/COPY).
•The other party’s machine is not a facsimile. Check with the other
party.
•The number you dialed is not in service.
PRESSED THE STOP KEY — •The fSTOPl button was pressed and fax communication was
canceled.
THE COVER WAS OPENED — •The cover was opened. Close it and try again.
OK — • Fax communication was successful.
X
T3
For Fax Advantage Assistance, Call 1 -800-435-7329.
99