Front panel controls and functions, Continued), Amplifier – Panasonic SC-CH33 User Manual
Page 10: Amplifier controls, Power “standby 6/on” switch (power standby (b/on), Spectrum analysis display, Full range level display, Super bass indicator, Equalizer controls, Graphic equalizer level)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Front Panel Controls and Functions
(continued)
Amplifier
■ Amplifier controls
® Power “STANDBY 6/ON” switch
(POWER STANDBY (b/ON)
This switch switches ON and OFF the secondary circuit power
only. The unit Is in the “standby” condition when this switch is
set to the STANDBY (!) position. Regardless of the switch
setting, the primary circuit is always “live” as long as the
power cord is connected to an electrical outlet.
® Spectrum analysis display
Shows the spectrum analysis level for each frequency range.
@ Full range level display
Shows the full range level.
@ Super bass indicator
Lights when you activate the super bass mode.
® Equalizer controls
(GRAPHIC EQUALIZER LEVEL)
Use to adjust the equalization level.
These controls are for compensation of tonal quality. By sliding
the controls at each of the indicated frequencies in the “+”
direction, the tonal quality is increased, and by sliding them in
the direction, the tonal quality is decreased.
(See page 44.)
0
Volume level control (VOLUME)
Turn to adjust the volume level.
When turning the control, the alphanumeric dispiay shows the
volume level.
Note that — dB is the lowest volume setting and 0 dB is the
highest.
® Volume preset button (VOL PRESET)
Use to preset volume for timer play.
® Remote control signal sensor (SENSOR)
Receives the signals from the remote control.
0
Super bass button (SUPER BASS)
Press to boost the dynamic tow-frequency ranges.
@
Input select buttons (TAPE, AUX, CD, TUNER)
Press to select the sound source.