Panasonic SC-CH33 - Manual (Page 57)

Guide
requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
ifninor adjustment on your part may eliminate the problem and restore proper operation.
n you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
Problem Probable cause(s) Suggested remedy
Problems common to all systems
There is no sound when the
power is ON and no bar
appears on the volume
level display.
Volume is set too low. Adjust the volume level with the volume control on
the amplifier.
The location of the various
musical instruments is not
well defined.
The (+) and (-) connections to one of the
speakers are reversed. Connect the speaker cord correctly.
The left and right sounds
are reversed. The left and right connections to the speaker are
reversed.
Connect the speaker cord correctly.
Only one speaker is
emitting sound.
One of the wires of the speaker cord is
disconnected. Connect the speaker cord correctly.
There is no sound when a
source is being played. The (+) and (-) wires of the speaker cords are
shorted. Switch the system to the standby mode, reconnect
the speaker cords so that they are not shorted.
Then switch on the power.
There is a low-frequency
hum when a source is
being played. A power cord or a fluorescent light is located near
a connecting cord. Keep electrical appliances well away from the
connecting cords.
The ERROR indicator
appears on the display for
about 1 second.
The wrong operation has just taken place. Perform the correct operation of the present step
again.
While listening to FM broadcasts
There is a “rushing” noise
during a stereo broadcast
which is not audibte during
a monaural broadcast.
You hear excessive noise
during a stereo broadcast,
and occasionally the sound
disappears.
The stereo indicator of the
tuner flickers and does not
light completely.
The sound during a stereo
broadcast Is highly
distorted.
Noise is more likely to appear on a stereo signal
than on a monaural signal.
The installation location and orientation of the
antenna are unsuitable.
The transmitting station is a long distance away.
There is a building or mountain nearby. [Distortion
is caused by interference between the signal from
the transmitting station (direct wave) and the
signal reflected from the building or mountain
(reflected wave).]
• If you are using an indoor antenna, change to an
outdoor antenna.
•If you are using a special outdoor antenna, try
changing the installation location, height, and
orientation.
•Try switching oft the television or VCR.
•Press the FM mode button to change the reception
from stereo to monaural mode.
While listening to MW/LW broadcasts
■ You hear an unusual beat You are using the system at the same time you Switch off the TV set, or use the system farther away
sound. are playing a TV set. from it.
' You hear a low-frequency
hum.
The antenna wire is near the power cord. Separate the antenna wire from the power cord.
57