Connections, Note, S{separator)1-video terminal – Panasonic TX-47WG25 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connections
How to connect the “AVI, 2 or 3” Input Terminals.
(VHS VCR)
I
o
oOOD OOO
I
m
n)
Audio
Video
p OUT |_
OUT
Note:
(1) When AVI, AV2 or AV3 is selected, and that AV mode has no input picture signal, the Background Colour of the
screen will change. (This only occurs if the Blue-Back function is set to the ON condition; refer to page 50 for
details.)
(2) When an S-Video cable is connected to the SI-Video terminal, the Phono Video input will be automatically
switched off for that AV mode.
(3) When a Monaural VCR is used, connect the Monaural Audio cable to the Audio “LEFT’ terminal.
(4) Simitar connections are available at the AVI, AV2 and AV3 input terminals.
Select the desired AV input position by pushing the TV/AV Mode selection button. (Refer to page 30)
S{Separator)1-Video Terminal
The S1-Video terminal on this set is a separator luminance (Y) and chrominance (C) signal terminal which supports
videos compatible with wide TV. When a full image from the S1 Video terminal of special video is detected by the
set, the screen size automatically sets to full. Connection is established with priority given to the S1-video when the
SI-video input terminal and the video input terminal are connected at the same time. Thus connection is not required
for video input. Also, when connecting, connect the audio mode at the same time.
14