Panasonic TX-47WG25 - Manual (Page 7)

Before Operating This Set
Connect the Piug to the Wall Outlet
Note:
Mains plug types vary between countries.The mains plug
shown at left may therefore not be the type fitted to your
set.
When connecting the mains plug to the wall outlet, on the
right side of power indicator will light (Red).
How to Turn the Power On
Push the Power Switch on the set to turn the set on.
The Power Indicator ((i)) left side will light.
Power-OFF........Indicator not illuminated
Stand-by (i) .......Red
Power-ON..........Green
Note:
When in the Stand-by condition (Refer to page 30), it is
possible to turn the TV set on by pushing the “Power
(Stand-by)” Button or the “Direct Programme Number
Selection” Buttons (0-9), Programme Number Up or Down
Buttons either on the TV set or Remote Control.
Battery Installation
Apply slight downward pressure while pulling
towards the bottom.
Two “R6 {AA)" size
Batteries: Use two "R6 (AA)” size batteries.
Insert the batteries ensuring correct polarity.
This is identifiable by the V and symbols
on both the batteries and inside the battery
compartment.
Replace the cover
Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.
A Battery cautions
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the
batteries to burst.
Old Batteries New Batteries
^// \w
Replace both batteries at the same time. Don't mix battery types
{alkaline with carbon zinc, etc.) Don’t Recharge.