Panasonic TX-47WG25 - Manual (Page 37)

Advanced Remote Control Operation
MODE
AUDIO SWAP
%
Sub picture TV/AV MODE
Selection
To change the Mode of the Sub
picture, push the “MODE” Button.
By pushing the “MODE” Button,
select the Sub picture mode as
follows.
1^ TV ^ AV1 ^ AV2 -I
--------- AV3 <---------
Audio Swap
The AUDIO SWAP button is the
changeover button for the sounds
(audio programme content) of the
Main and Sub picture.
Push this button to hear the sound
of the Sub picture. However, note
that the sound of Main picture can
not be heard when the Sub picture
sound is selected.
(Two Window Mode)
SEARCH
Sub picture channel SEARCH
By pushing this button, it is possible
to search through all programmed
positions (Skip off) and display a
picture in the Sub picture screen.
Two Window Mode
'rnhJ -i-
ri— “t-
i
Picture Out Picture Mode
(Picture-Out Picture Mode)
£3
Push again to cancel.
[A]
t
1
Push again to stop the channel
search.
STILL
The Still function can be used to
freeze the action on the screen and
display a still picture of the Sub
picture.
Push the “STILL" button, the Sub
picture changes to freeze the
moving picture into a still picture.
Push again to cancel.
When pushed in normal mode
(Multi Window mode OFF), a freeze
frame of the Main Picture will be
displayed as a sub-picture while the
action In the Main picture
continues.
Note:
If still picture cannot be avoided,
reduce the brightness and contrast
levels of the picture to minimize any
damage that might occur.
Sub picture Programme Number
Selection
Push the Sub picture Programme
Number Up
V’ or Down V’ Button
to select the next higher or lower
tuned channel.
37