Panasonic TX-47WG25 - Manual (Page 34)

Advanced Remote Control Operation
Manual ASPECT Operation
1 ASPECT Button
Even when this set is in 4 : 3 screen mode,
you can widen the picture width to the full
screen and enjoy a close-up image.
By pushing the “ASPECT Button, you can
sequentially select the Aspect Ratio as
below.
Wide Screen condition is as shown below.
V Mode TEXT Mode AV Mode
4:3 - -► FULL !-► 4:3
i
ZOOM1 - -► FULL ZOOM1
i 1
ZOOM2 ^ FULL ZOOM2
FULL - ^ FULL FULL
4
JUST - -► FULL JUST
J _____ J
Note:
(1) The screen size wilt be stored in memory
for each mode (TV, AV1, AV2 and AV3).
(2) The screen position can be changed in
the ZOOM 1, ZOOM 2 and JUST modes,
and the side band can be changed in the
4 ; 3 mode (Refer to page 49 for details).
(3) When a full picture signal from the special
video is detected by SI-Video Terminal of
the set, the screen size automatically sets
to FULL.
(4) The monitor output will not change even if
the screen size and screen position are
adjusted.
(5) There is a wide variety of laser discs and
similar software available with aspect
ratios from 1.78 : 1 (16 : 9) to 2.35 : 1
(cinema vision).
Therefore, black portion will be visible at
the top and bottom of the screen even in
ZOOM 1 (16:9) mode depending on the
software (for example: cinema vision).
34