Panasonic TX-47WG25 - Manual (Page 30)

General Operation
1
®
d
How to switch the power ON or OFF
The TV set must first be switched on at the
wall outlet and at the Power Switch. {Refer to
page 7)
Push this button to turn the TV set ON, from
STANDBY mode.
Push it again to turn the TV set OFF,
STANDBY mode.
Note:
It is also possible to turn the TV set on
STANDBY by pushing the “Direct Pro­
gramme Number Selection” Buttons (0-9)
and the “Programme Number Up or Down”
Button, either on the set or on the Remote
Control.
Programme Number Selection
Push the Programme Number Up
“ a ”
or
Down “v" Button to select the next higher or
lower Programme number.
Direct Programme Number Selection
(CH SELECT = POS.)
You can select the numbers directly by
pushing “Number 0 - 9” button and the two
digit Numbers by pushing “Two Digit” and
“Programme Number” buttons.
Programme Number 8....... @
Programme Number 12.....
Direct Programme Number Selection
(CH SELECT = DIRECT)
You can select the number directly by push­
ing the corresponding programme number
button.
Programme Number 8....... ®
Programme Number 36..
©.(D
Programme Number 124.... ©)> ©.©
Note:
When the Skip setting for Programme
Number 100 through 125 is on, the channel
Selection time will be shorted, and thus you
can not input three digits at a time.
TV/AV
TV/AV Mode Selection
Push the “TV/AV" Button to select
TV, AVI, AV2, AV3 input signal
modes sequentially.
30