360 Systems MAXX-1000SD - Manual (Page 21)

MAXX Owner’s Manual Page 21
Image Server Hardware Interface
Front Panel Features
Power ON/OFF button
The blue front panel button initiates start-up and shut-down of the Image Server. Press it
momentarily to start the server. A sequence of start-up screens will appear, ending with the 3-
channel graphic user interface.
When the Image Server is running, pressing the blue button momentarily will cause the system
to begin an orderly shutdown. This can also be initiated from the GUI by selecting
START > SHUTDOWN > SHUTDOWN. In most cases the power will shut off automatically,
however if the front panel lights begin to blink the file system has been properly closed and it is
safe to force the power off by holding the front panel button in for 4 seconds.
In the event that the system has stopped responding to commands and will not shutdown, hold
the button in for 4 seconds to force a power down.
Do not use the rear panel switch on the power supply to shut down the Image Server. Abrupt
power loss can cause loss of information stored on the disk array. The rear panel power switch
can be used to prevent re-application of power during service procedures once the normal shut
down sequence is complete.
CAUTION:
LOSS OF DATA CAN OCCUR IF THE POWER IS TURNED OFF WITHOUT A SHUTDOWN.
USE THE FOUR SECOND SHUTDOWN ONLY IF THE SYSTEM IS NOT RESPONDING OR
THE SHUTDOWN PROCESS DOES NOT TURN THE POWER OFF AUTOMATICALLY.
Indicators
Five blue LED Status Indicators appear on the front panel. The POWER, FANS, DRIVES and
SYSTEM indicators are illuminated continuously when the system is functioning normally.
GENLOCK will be off when Internal Sync is selected, and illuminated when Genlock is
selected. See the table Front Panel Indicators on page 105 for diagnostic meanings.