360 Systems MAXX-1000SD - Manual (Page 49)

MAXX Owner’s Manual Page 49
Each Image Server is shipped with a default network Host Name and IP Address. Qualified
network engineers may change these configurations to suit your specific network environment.
Factory defaults for networking are:
• Network Disabled
• Use DHCP
Disabling the Network [X]
This selection turns the network OFF or ON. The default is ON, but can be turned off to deny
access to/from the network for security purposes.
Enabling/Disabling DHCP [X]
Enabling DHCP will configure the network interface automatically.
If the DHCP box is not selected, the user may then manually enter assignments in the
following windows:
• IP Address ( Example: 192.168.1.20 )
• Net Mask ( Example: 255.255.255.0 )
• Default Router ( Example: 192.168.1.1 )
The Host Name and NTP domain name may be a fully qualified domain name, such as
edit1.mydomain.com. All other manually configured addresses must be properly formatted IP
addresses.
Saving Network Configuration
Click on OK, APPLY, or CANCEL to accept or abandon new entries.