Cisco 12000/10700 V3.1.1 - Manual (Page 574)

21-2
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 21 Troubleshooting and FAQs
Administration
What Dialogs Use the IOS CLI Instead of SNMP?
Q. What dialogs are retrieving or configuring information using the IOS CLI instead of SNMP?
A. In Cisco 12000/10720 v3.1.1 Router Manager some dialogs use only the IOS CLI, some use only
SNMP, and some use both IOS CLI and SNMP.
Table 21-2 , Table 21-3 , and Table 21-4 detail each
instance.
When a dialog uses the IOS CLI, the IOS password must be set up. See Entering or Changing IOS
CLI Username and Passwords, page 4-5 .
Table 21-2 Dialogs launched from Chassis objects
Dialog uses IOS CLI
(Need to set the Management
Passwords on the EM)
Dialog uses SNMP
Dialog uses IOS CLI and SNMP
(Need to set the Management
Passwords on the EM)
Configuration Editor Chassis Configuration SNMP Management
POS APS Status Chassis Management Information ATM Connection Upload
RPR Configuration Chassis Inventory BGP Configuration
RPR Status Chassis Status BGP Status
BGP Address-Family Synchronization System Log OSPF Status
BGP Address-Family Configuration Command History
BGP Address-Family Status TCP Status
OSPF Configuration UDP Status
MPLS Forwarding Information IP Routing Status
MPLS Trap Configuration Dialog MPLS Interface Status
VRF Deployment MPLS Tunnel Information
VRF Configuration MPLS LDP Entity Status
MPLS LDP Peer Status
MPLS LDP Hello Adjacencies
VRF Status
VPN Status
Interface VRF Status
VRF Object Status
Table 21-3 Dialogs launched from Module objects
Dialog uses IOS CLI
(Need to set the Management
Passwords on the EM)
Dialog uses SNMP
Dialog uses IOS CLI and SNMP
(Need to set the Management
Passwords on the EM)
WRED-Rx Configuration Module Performance
Module Inventory
Module Status