A&D Weighing HR-202i - Manual (Page 12)

10
4. Display Symbols and Key Operation
Display
Key operation
Press and release the key immediately" or "Click the key"........................................
Press and hold the key ................................................................................................
Key When pressed and released When pressed and held
The key to turn the display ON and OFF.
The standby indicator is displayed when the display is turned off.
The weighing mode is enabled when the display is turned on.
This key is available anytime.
Pressing the key during operation will interrupt the operation and turn the display
OFF.
In the weighing mode, the key to turn the
minimum weighing value ON and OFF. The key to enter the function table
mode. Refer to "10. Function Table".
The key to switch the preset weighing
units stored in the function table. Refer to
"5. Weighing Units".
The key to perform response
adjustment.
No function.
The key to display other items of the
calibration menu.
The key to output the stable weighing
data. (factory setting)
No function. (factory setting)
By changing the function table:
"Title block" and "End block" for
GLP report are output.
The key to set the display to zero.
Weighing data
or settings
Units
Response indicator
(Displayed for about 30 seconds
when weighing starts.)
Processing indicator
Stabilization indicator
Standby indicator
of power supply