Acura 2014 TSX - Owner's Manual - Manual (Page 110)

109
uu Operating the Switches Around the Steering Wheel u Wipers and Washers
Wipers and Washers
The windshield wipers and washers can be
used when the ignition switch is in ON
( w .
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■
Adjusting the delay
Turn the adjustment ring to adjust the
wiper delay.
■
Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.
■ Windshield Wiper/Washer 1 Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving, the
wipers make a single sweep.
When the vehicle speeds up, the wiper operation's
shortest delay setting ( ) and the LO setting
become the same.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
Intermittent Time
Adjustment Ring
Pull to
use
washer.
MIST
INT: Low speed with
intermittent
OFF
LO: Low speed wipe
HI: High speed wipe
Long delay
Short delay
14 ACURA TSX 4D-31TL16500.book 109 ページ ２０１３年６月１７日 月曜日 午前９時４０分
QRG
Index
2014 TSX
Co
ntrols
TOC