Transmission fluid, 2 automatic transmission fluid p. 244, Automatic transmission fluid dipstick – Acura 2014 TSX - Owner's Manual User Manual

Page 245: Yellow, Loop), Automatic transmission, Fluid, Dipstick

Advertising
background image

244

uu

Maintenance Under the Hood

u

Transmission Fluid

Transmission Fluid

Check the fluid level when the engine is at normal operating temperature.

1. Park on level ground, and start the engine.

2. Wait until the radiator fan starts and then

turn off the engine.

u

Perform step 3 after waiting for about 60
seconds (less than 90 seconds).

3. Remove the dipstick (yellow loop) from the

transmission and wipe it with a clean cloth.

4. Insert the dipstick all the way back

into the transmission securely, as shown
in the image.

5. Remove the dipstick and check the

fluid level.

u

It should be between the upper and
lower marks in the HOT range.

6. If the level is below the lower mark,

add fluid into the dipstick hole to bring it
to the level between the upper and lower
marks, and have your vehicle checked by
a dealer immediately.

Automatic Transmission Fluid

Specified fluid: Acura ATF DW-1 (automatic transmission fluid)

1

Automatic Transmission Fluid

NOTICE

Do not mix Acura ATF DW-1 with other
transmission fluids.
Using a transmission fluid other than Acura ATF
DW-1 may adversely affect the operation and
durability of your vehicle’s transmission, and damage
the transmission.

Any damage caused by using a transmission fluid that
is not equivalent to Acura ATF DW-1 is not covered
by Acura’s new vehicle warranty.

NOTICE

Pour the fluid slowly and carefully so you do not spill
any. Clean up any spills immediately; they can
damage components in the engine compartment.

Upper Mark
Lower Mark

HOT

Range

Upper
Lower
Marks

Rubber
Cap

Guide

4-cylinder models

6-cylinder models

14 ACURA TSX 4D-31TL16500.book 244 ページ 2013年6月17日 月曜日 午前9時40分

QRG

Index

2014 TSX

Main

tenan

ce

TOC

Advertising