Acura 2014 TSX - Owner's Manual - Manual (Page 202)

201
uu When Driving u Shifting
Continued
Shifting
Fully depress the clutch pedal to operate the shift lever and change gears, then
slowly release the pedal.
Depress the clutch pedal, and pause for a few seconds before shifting into ( R , or
shift into one of the forward gears for a moment. This stops the gears so they do
not “grind.”
When you are not shifting, do not rest your
foot on the clutch pedal. This can cause your
clutch to wear out faster.
■ Shift Lever Operation
Manual transmission models
1 Shifting
NOTICE
Do not shift to ( R before the vehicle comes to a
complete stop.
Shifting to
( R before stopping can damage the
transmission.
NOTICE
Before downshifting, make sure the engine will not
go into the tachometer’s red zone. Should this occur,
it can severely damage your engine.
There is a metallic part on the shift lever. If you leave
the vehicle parked outside for a long time on a hot
day, be careful before moving the shift lever. Because
of heat, the shift lever may be extremely hot. If the
outside temperature is low, the shift lever may feel
cold.
Recommended Shift Points
Driving in the highest gear that allows the engine to
run and accelerate smoothly helps to optimize fuel
economy and effective emissions control. The
following shift points are recommended:
If you exceed the maximum speed for the gear you
are in, the engine speed will enter into the
tachometer’s red zone. When this happens, you may
experience a slight jolt.
Shift Up Normal Acceleration
1st to 2nd 17 mph (27 km/h)
2nd to 3rd 29 mph (46 km/h)
3rd to 4th 37 mph (59 km/h)
4th to 5th 43 mph (69 km/h)
5th to 6th 49 mph (79 km/h)
14 ACURA TSX 4D-31TL16500.book 201 ページ ２０１３年６月１７日 月曜日 午前９時４０分
QRG
Index
2014 TSX
Driving
TOC