BASO BGH2UNCNTRLHT-01 - Manual (Page 19)

BGH2UNCTRLHT-01 Universal Hot Surface Ignition Control Installation Instructions 19
Technical Specification
Product BGH2UNCNTRLHT-01 Universal Hot Surface Ignition Control
Ignition Type Hot Surface Ignition (HSI)
Ignition Source High voltage (120/240VAC) HSI (Hot Surface Igniter)
Flame Sense Cable Maximum Length 48 in. (1,220 mm)
Flame Detection Means Flame Rectification
Flame Detection Type Internal or Remote
Flame Failure Response Time 2.0 seconds maximum
Warmup Time (Timed Ignition) 17, 34, or 45 seconds
Pre-Purge Time None, 17, 30, or 32 seconds
Between Trial Purge Time None, 60,77,90 or 96 seconds
Ignition-Trial-Time (Before Lockout) 4 or 7 seconds
Number of Trials (Before 100% Shutoff) 1 or 3
Power Requirements Control:
Operating Current: 24 VAC (+/- 20%), 50/60 Hz.
0.2 A nominal + valves
Gas Valve Relay Contact Rating 2 A maximum @ 24 VAC
Hot Surface Ignition Relay Contact Rating 3 A maximum @ 240 VAC
6 A maximum @ 120 VAC
Wiring Connections 1/4 in. (6.35 mm) male spade
Maximum Firing Rate 400,000 Btu/hr (117 kW)
Ambient Operating and Storage
Temperature -40 to 175 °F (-40 to 79°C)
Humidity 95% RH non-condensing
Type of Gas Natural, Liquefied Petroleum (LP), Manufactured, Mixed or LP Gas-Air
Mixture
Packaging Bulk pack supplied to original equipment manufacturer (individual pack
[-1AAC] or individual overpack [-1AAE, 20 per box] optional)
Bulk Pack Quantity 25
Pack Weight Bulk pack (-1AAD) 14 lb (6.36 kg)
Individual pack (-1AAC) 1 lb (.454 kg)
Individual overpack (-1AAE) 18 lb (8.17 kg)
Agency Listing CSA Certificate Number 246569-2213607
Specifications Standards ANSI Standard Z21.20
CAN/CSA-C22.2 No. 199
The performance specifications are nominal and conform to acceptable industry standards. All agency certification of BASO products is
performed under dry and controlled indoor environmental conditions. Use of BASO products beyond these conditions is not recommended and
may void the warranty. If the product is exposed to water (dripping, spraying, rain, etc.) or other harsh environments, it must be protected. The
original equipment manufacturer or end user is responsible for the correct application of BASO products. For questionable applications, please
consult BASO Gas Products LLC. BASO Gas Products LLC shall not be liable for damages or product malfunctions resulting from
misapplication or misuse of its products.
1007 South 12th Street
PO Box 170
Watertown, WI 53094
www.baso.gas
1-877-227-6427 (1-877-BASOGAS) Published in U.S.A.