BMW 2012 5 Series User Manual

Page 147

Advertising
background image

The LED flashes slowly.

5.

Release both buttons when the LED flashes
rapidly.
If the LED does not flash rapidly after approx.
60 seconds, change the distance and repeat
the step.
Canada: if the LED is not flashing rapidly af‐
ter approx. 60 seconds, change the distance
and repeat the step, or, if the programming
was interrupted by the hand-held transmit‐
ter, hold down the memory button and press
and release the button on the hand-held
transmitter again for 2 seconds.

6.

To program other hand-held transmitters,
repeat steps 3 to 5.

The device can be operated using the memory
button with the engine running or the ignition
switched on.

Malfunction

If the device cannot be used after repeated at‐
tempts at programming, please check whether
the hand-held transmitter is equipped with an
alternating code system.
To do so:

Read the instructions of the hand-held
transmitter.

Hold down the memory button of the
integrated universal remote control longer.

If the LED of the integrated universal remote
control flashes rapidly for a brief period and then
lights up continuously, the hand-held transmit‐
ter is equipped with an alternating code system.
In this case, program the memory buttons as
described under Alternating-code hand-held
transmitters.

Alternating-code hand-held

transmitters

Please obtain information on synchronizing the
device in the operating manual of the device be‐
ing set up.

Programming will be easier with the aid of a sec‐
ond person.

1.

Park the vehicle within range of the remote-
controlled device.

2.

Program the integrated universal remote
control as described above under Fixed-
code hand-held transmitters.

3.

Locate the button on the receiver of the de‐
vice to be set, e.g., on the drive.

4.

Press the button on the receiver of the de‐
vice to be set. You have approx. 30 seconds
for the next step.

5.

Hold down the programmed memory button
of the integrated universal remote for ap‐
prox. 3 seconds. Repeat this work step, if
necessary, up to three times.

The device can be operated using the memory
button with the engine running or the ignition
switched on.

Reassigning individual programs

1.

Switch on the ignition.

2.

Hold the hand-held transmitter a distance of
approx. 1 to 3 in/2.5 to 8 cm from the mem‐
ory buttons.
The required distance depends on the
manual transmitter.

3.

Hold down the memory button of the
integrated universal remote control.

4.

If the LED flashes slowly after approx.
20 seconds, press the transmit button on
the hand-held transmitter.

5.

Release both buttons when the LED flashes
rapidly.
If the LED does not flash rapidly after approx.
60 seconds, change the distance and repeat
the step.

Canada: if the LED is not flashing rapidly after
approx. 60 seconds, change the distance and
repeat the step, or, if the programming was in‐
terrupted by the hand-held transmitter, hold
down the memory button and press and release

Seite 147

Interior equipment

Controls

147

Online Edition for Part no. 01 40 2 607 879 - 09 11 490

Advertising