BMW 2012 5 Series User Manual
Page 98
A change in the tire inflation pressure during
driving is taken into account.
A correction is only necessary if this is indicated
by the TPM
Wheels, green
The tire inflation pressure is equal to the target
state.
One wheel is yellow
A flat tire or major drop in inflation pressure in
the indicated tire.
All wheels are yellow
▷
A flat tire or major drop in inflation pressure
in several tires.
▷
The system was not reset after a wheel
change and thus warns based on the infla‐
tion pressures initialized last.
▷
A flat tire in one or more tires while the sys‐
tem is being reset.
Wheels, gray
The system cannot detect a flat tire. Reasons for
this may be:
▷
TPM is being reset.
▷
Disturbance by systems or devices with the
same radio frequency.
▷
Malfunction.
For Canadian models: additional
information
The status display additionally shows the cur‐
rent tire inflation pressures and tire tempera‐
tures.
When correcting the tire inflation pressures,
note the following:
The tire pressure increases as the tire temper‐
ature increases.
Therefore, only correct the tire inflation pres‐
sure when the tire is at the ambient temperature.
Compare the displayed tire temperature with
the external temperature in the instrument clus‐
ter.
Resetting the system
Reset the system after each correction of the
tire inflation pressure and after every tire or
wheel change.
1.
"Vehicle Info"
2.
"Vehicle status"
3.
"Reset"
4.
Start the engine - do not drive away.
5.
Reset the tire pressure using "Reset".
6.
Drive away.
The tires are shown in gray and "Resetting
TPM..." is displayed.
After driving for a few minutes, the set tire infla‐
tion pressures are applied as set values. The re‐
setting process is completed automatically dur‐
ing driving. The tires are shown in green and
"TPM active" is shown on the Control Display.
The trip can be interrupted at any time. If you
drive away again, the process resumes auto‐
matically.
If a flat tire is detected during a reset, all tires are
displayed in yellow.
Low tire pressure message
The yellow warning lamp lights up. A
Check Control message is displayed.
▷
There is a flat tire or a major loss in
tire inflation pressure.
▷
The system was not reset after a wheel
change and thus warns based on the infla‐
tion pressures initialized last.
1.
Reduce your speed and stop cautiously.
Avoid sudden braking and steering maneu‐
vers.
2.
Check whether the vehicle is fitted with reg‐
ular tires or run-flat tires.
Seite 98
Controls
Safety
98
Online Edition for Part no. 01 40 2 607 879 - 09 11 490