Canon imageRUNNER C3100 N - Manual (Page 45)

Settings Menu 2-15
2
Pr
inter Settings Men
u
Job Securing Time
1 hour * , 2 hours, 3 hours, 6 hours, 12 hours, and 24 hours
When a secured print job is sent to the machine, it is stored on the machine's hard
disk, and a password must be entered before the job can be printed. This setting
specifies how long the job will be stored before it is automatically canceled.
NOTE
• Even if the time period specified with this setting has not elapsed, the print job data
is deleted if the main power to the machine is switched OFF.
• The password is set from the printer driver.
Timeout
Timeout (5 to 300 seconds), Off; 15 * seconds
When the Personality is set to 'Auto', the machine detects the control commands
and starts printing in the appropriate mode. After all the data has been received
and the end of the data is detected, the print mode stops. This processing of print
data is called a job.
If the data for a job does not end, the machine does not start the next job even if it
receives other print commands. In cases like this, use the Timeout setting to force
jobs to finish if no data is received during the set period of time.
If Timeout is 'On', jobs can finish automatically. For example, if print data still
remains in the machine because a form feed command cannot be processed, the
paper can be fed automatically.
If Timeout is 'Off', jobs will not end automatically.
IMPORTANT
• If this function is set so that a job will timeout, the machine may end a print job
before all the data has been received if it takes a long time for the PC to send the
data. If this occurs, adjust the length of the Timeout setting.
• If [Off] is selected, you will not be able to make copies until print jobs that use the
staple sort and punch settings have been completed.
• If you send data from a printer driver not compatible with the machine, and the end
of job command is not received within the time set in this setting, the machine
cancels the job, which may cause the data to be printed incorrectly.
NOTE
When a job is being processed, the Processing/Data Indicator on the control panel
flashes.