Connecting the ac power cord, Wiring the dc power supply – Cisco XM Universal Gateways Cisco AS5400XM User Manual
Page 43
3-13
Cisco AS5400XM Universal Gateway Chassis Installation Guide
OL-6418-02
Chapter 3 Installing the Cisco AS5400XM Universal Gateway
Supplying Power
Warning
The device is designed to work with TN power systems. Statement 19
Connecting the AC Power Cord
To connect the power cord, follow these steps:
Step 1
Connect one end of each power cord to the power connectors on the rear panel. (See
.)
Figure 3-14
Connecting the AC Power Cord
Step 2
Latch the clips provided on the power supply of the chassis to each power cord.
Step 3
Connect the other end of the power cords to the power outlets.
Warning
The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device. Statement 1019
Step 4
Power up the Cisco AS5400XM universal gateway.
The internal power supply fan should power up.
Wiring the DC Power Supply
If you ordered the Cisco AS5400XM universal gateway with a DC power supply, follow the procedure
in this section to wire the terminal block.
Note
The grounding architecture for the Cisco AS5400XM universal gateway is isolated DC return (DC-I).
30851
Power switch