Bobbin winding (continued) – Kenmore 385.15208 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bobbin winding (continued)
U] Push the bobbin to the right,
[
7
] With the free end of the thread held in your hand,
depress the foot control., Stop the machine when the
bobbin has made a few turns, and cut the thread close
to the hole in the bobbin,.
] Depress the foot control again. When the bobbin is fuliy
wound, it stops automaticaliy. Return the bobbin winder
to its original position by moving the spindle to the left,
and cut the thread.
[
9
] Push in the handwheel to engage the clutch.
* The machine does not function until the clutch is
engaged.
NOTE:
The position of the bobbin winder stopper is adjustable
depending on required amount of thread on bobbin
(i.e, 1/2 full or full). Use a screwdriver and loosen the
screw one turn or less. Do not take the screw all the way
out. Adjust the position of the bobbin winder stopper.
Retighten the screw.____________________
20