Kenmore 385.15208 - Manual (Page 38)

stitch Pattern Selector
© Setting mark
(D Stitch pattern selector
The stitch pattern selector determines the stitch you select.
NOTE; ^ ""
To avoid needle or fabric damage, make sure the needle
is up and out of the fabric while selecting a stitch.
Stitch patterns are color-coded to recommended setting
zone on the stitch length control.
ZONES:
Red: Straight, zigzag and utility stitches
Green: Geometric decorative stitches
Blue:
Built-in buttonhole
H {Model 15208)
ifr (Model 15202)
Stitch Length Dial
©Setting mark
Turn the stitch length dial until the setting mark reaches the
desired stitch length. The higher the number the longer the
stitch. “ 0 ” means “no feed”,
• “ CZ3 ” is the recommended setting for buttonhole
stitching.
“ Adjust the stitch length dial in the 0.5-4 range when you
sew the zigzag stitch.
NOTE:
Study the red, green and blue zones on the stitch length
control. These are recommended zones of stitch length
and are color-coded to the stitches.
Stitch Width dial
Turn the stitch width dial until the setting mark reaches the
desired stitch width.
The higher the number, the wider the stitch width.
© Setting mark
When the stitch width is narrow, the right side of the
pattern will be cut off (model 15208),
Example: Pattern 5 Width [5| Width [3]
NOTE:
Raise the needie above the fabric, when you turn the
stitch width dial.________________________________
Reverse Stitch Control
Press the stitch control to sew in reverse.
30