Section vi. buttonhole, Buttonhole – Kenmore 385.15208 User Manual
Page 62
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION VI. BUTTONHOLE
Buttonhole
® Pattern selector:
(D Presser foot:
©Thread tension:
® Stitch length:
'D-J-M (BH)
Sliding buttonhole foot
1 to 5
CS {0.25 to 1)
To adjust buttonhole stitch density
Set the stitch length dial between 0.25 and 1.0 to adjust
the buttonhole stitch density.
NOTE: Always check a buttonhole on a scrap of fabric to
make sure the adjustment satisfies you.
Starting to sew
Snap the buttonhole foot (J) on the presser foot holder.
Carefully mark the buttonhole length on the fabric.
Place the fabric under the foot, with the buttonhole marking
running toward you.
Move the slider
(A)
toward you, so that the red arrow
(C)
on
the slider aligns with the start mark {B). Lower the presser
foot
NOTE:The markings on the slider are engraved in
centimeters.
Set the stitch selector at |0,, Sew forward until you reach the
front mark of your buttonhole. Stop sewing at a left stitch.
54