Kenwood KR-V9020 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Controls and indicators
REMOTE SENSOR _______ ______ ____ ___ __________
Point the supplied remote control unit towards this sensor
and operate.
SPEAKERS A and B keys —----------- --------------- -----------
Selects the speaker system to be used for listening.
The speaker system being used is shown on the display.
POWER key
- EQUALIZER key
Press this key to ON and the frequency characteris
tics of the sound will be modified by the graphic
equalizer.
In the DEFEAT position, the frequency characteris
tics remain unchanged.
Switches the power ON/STANDBY.
Power stand-by indicator
This indicator lights if the power cord is plugged into the
AC outlet. It is lit to show that the POWER key on the front
panel or the POWER key on the remote control unit can
be activated,
PHONES jack ---------------------------------------------------------- .
This jack accepts the standard stereo headphone plug.
When you wish to listen through headphones alone, set
the SPEAKERS keys (A and B) both to the OFF position.
EQUALIZER LEVEL control keys
Adjust these keys up and down to equalize the sound level
of the indicated frequencies with in a range of ±1 2 dB.
EQUALIZER FREQUENCY keys ------------------ ----------------
These keys are used to select the equalizing frequency
among 60 FIz, 1 50 Hz, 400 Hz, 1 kHz, 2.4 kHz, 6 kHz, and
1 5 kHz.
Display section
KB
n
IWOOD
AUD]0-VIDE
i
|
i
stereo
receiver
K^i-VSOZO
n
EQUALIZER PRESETS (A - E) keys
Use these keys to store equalizer patterns in memory
or to recall them.
Equalizer preset MEMO, key -------- ------------------------------
This key is used to store an equalizer pattern the PGM
PRESET memory.
Equalizer preset mode key (PGM/SET) -------------------
Each time this key is pressed, the recall mode of the
equalizer preset patterns alternates between PGM
(user programmed patterns) and SET (factory preset
patterns.)