Kenwood KR-V9020 - Manual (Page 27)

Example of video dubbing operation
■ To record with VCR1
When audio injection is not required (Through
dubbing):
1. Press the required VIDEO DUBBING key (|2 ► 1 L
|3 ► i1or[4~^).
2. Set the VCR 1 to the recording mode.
3. Set the playback VCR (VCR 2, VCR 3 or VCR 4) to the
playback mode,
When audio injection is required:
1. Press the VIDEO DUBBING lOFFl key.
2. Select the playback VCR with the input selector keys.
3. Set the AUDIO INJECTION to ON,
4. Select the audio source to be injected using the input
selector keys.
5. Set the VCR 1 to the recording mode,
6. Play the required VCR and audio source component.
■ To record with VCR 2
1. Press the VIDEO DUBBING [OFFl key.
2. Select the playback VCR with the input selector.
(When Audio Injection is required)
(3) Set the AUDIO INJECTION to ON.
(4) Select the audio source used for audio injection
with the input selector,
3, Set the VCR 2 to the recording mode,
4, Start playing the playback VCR,
(When the audio injection is ON, also play the audio
source component,)
Note:
The rear panel video output jacks do not output a video signal in
the following cases;
Signal input
jack
Jacks with no output
S-VIDEO flNl jack
of "VIDEO 2"
VIDEO OUT jacks
of each "VIDEO"
VIDEO jack of
"MONITOR OUT"
VIDEO EN] jack
of each "VIDEO"
S-VIDEO |0UT|
jack of "VIDEO
2"
S-VIDEO jack of
"MONITOR OUT"
• Since the S-VIDEO and VIDEO circuits are independent of each
other, dubbing/playback fronn an S-VIDEO jack to a VIDEO jack
or from a VIDEO jack to an S-VIDEO jack is impossible.
However, dubbing/playback from the S-VIDEO jack of "VIDEO
4" to each VIDEO jack is possible.
The relationships between the various video terminals are
shown in the table on the left.
• When a video component or TV monitor having an S-VIDEO
jack is used, be sure to connect both the S-VIDEO jack and the
(composite) VIDEO jack to the S-VlDEO and VIDEO jacks of this
unit.