Operating instructions, Basic operation – Kenwood KR-V9020 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating instructions
POWER key
EQUALIZER key
CD DIRECT indicator -
Point indicator
VOLUME
CONTROL
knob
EQUALIZER control keys
Input selector keys
BALANCE knob
STAND BY mode of POWER key
When the power cord of this system is plugged into an
AC outlet, the STAND BY indicator lights up regardless
of the ON/OFF setting of the POWER key. This
indicates that a small amount of current is being
supplied to the unit to back up the memory contents.
This mode is referred to as the Stand By mode. While
the STAND BY indicator is lit, the power of the system
can be switched ON/OFF from the remote control unit, ■
To mute the sound temporarily
Press the MUTE key,
• The point indicator blinks, and the output is muted.
• When the MUTE key is pressed again, the muting is
canceled, the point indicator lights steadily and the
previous output level is resumed.
The mute mode can also be released by changing the
output level using the remote control unit.
• The point indicator also blinks (for approx, 4 seconds)
when the muting functions is engaged immediately
after the power is turned ON.
■ Basic operation
1. Press the POWER key to ON,
• The display lights and the unit becomes operative.
• Pressing the key again switches the power OFF.
2. Press one of the input selector keys to select the input
source to be played.
• If a System Control cord has been connected to the
selected source component, it starts play automati
cally due the Automatic Play operation feature.
• With the Automatic Play operation feature, when one
of the source components is started to be played, the
corresponding
input
selector
is
automatically
switched for the source.
• The selected input source is shown on the display.
3. If automatic play operation using the System Control
cords has not been set, start playing the source com
ponent selected.
4. Adjust the output level with the VOLUME CONTROL
knob.
• When one of the VOLUME CONTROL keys on the
remote control unit is pressed, the point indicator
blinks and the VOLUME CONTROL knob is rotated.
5. Adjust the balance of the left and right output levels
with the BALANCE knob.
6. Adjust the tone referring to the description in the
"Graphic equalizer" section.
• The graphic equalizer effect can be switched ON/
DEFEAT by pressing the EQUALIZER key.
Notes: --------------------------------- ------—----------------------- --------
1. The CD DIRECT key should usually be set to OFF (with the
indicator not lit).
2. When the TAPE-2 selector switch is set to ON, the input
source selected with the input selector keys cannot be heard
from the speakers. To listen to a source other than tape deck
2, be sure to set the TAPE-2 selector key to OFF,