Kenwood KR-V9020 - Manual (Page 26)

Playing video sources
■ To play a video source
(For Surround playback, refer to "Surround effects" on
page 28,)
1. Press the POWER key to ON.
2. Switch on the power of the monitor TV connected to
. the MONITOR OUT jack.
3. Select the playback source with the input selector keys,
4. Play the video component.
5. The video is reproduced on the monitor TV, and the
audio is reproduced through the speakers,
■ Dubbing between two VCRs
Video dubbing can be performed while listening to any
desired source,
With this receiver, through dubbing from VCR 2, VCR 3 or
VCR 4 to VCR 1 is possible.
To dub through from VCR 2 (or VCR 3 or VCR 4)
t o V C R I :
1. Press the VIDEO DUBBING |2 ► T1 (or |3 or
|4 ► 11) key.
• T h e l T H R Q U G H DUB. 2 ► 11
(or [THROUGH DUB, 3 ► 11
or [THROUGH DUB, 4 ► 11) indicator lights.
2. Set the VCR 1 to the recording mode.
3. Set the VCR 2 (or VCR 3 or VCR 4) to the playback
mode.
To stop through dubbing or after dubbing is
finished;
Press the VIDEO DUBBING |OFF] key.
• When through dubbing is not required, be sure to set
to the OFF mode.
Note: ---------------------------------------------- ------------------ ---------------------
The audio injection does not function during through dubbing
mode.
■ Audio injection
During video dubbing, the sound from the VCR can be
replaced with sound from any desired audio source
without affecting the picture.
In addition, the graphic equalizer effect can be applied to
the recorded audio source,
1. Press the AUDIO INJECTION key so that the
lAUDIO If^^ indicator lights.
2, Select the desired audio source for Audio injection
with the input selector keys,
3, When equalizer compensation is required when record­
ing a desired audio source with audio injection ON,
press the EO. REC key.
• The |EO REC| indicator lights up.
• Set the equalizer controls as desired.
4. Operate each VCR for dubbing,
Note: ---------------------- -----———-— ------------—-------------------
The audio injection does not function during through dubbing
mode.