Kenwood KR-V9020 - Manual (Page 21)

MEMORY key . Numeric (1 — 0/10) keys
Preset channel
TU NED Indicator
/ j S i i; i i r t i
... 1 i............ ly*
TU^
m
i
<ED BTERED ll-eo —
TO~i isiasi^ti’a
'"‘i n i.......... I 1
I... I I M L,
Preset function indicator
■ DiatTAL PELAY SURBOUNP SYSTEM VOLUME CONTROL
,3 M I 6 J 6
„
N
f—r E 3 A E I
ll 1 1 1 1 ll
B 7 B a o/io
ll 1 1 1 I ll
MEV mr DIRECT FU AM P.BCAK ll-?0
/11 /
Preset function
(1 ^ 10/1 1-20) key
P,SCAN key
DIRECT key
Direct tuning
This method allows the desired frequency to be entered
directly using the numeric keys, without using the TUN­
ING key.
1, Press the DIRECT key.
2, Enter the frequency of the desired station with the
numeric keys.
• When all of the digits of the frequency have been
entered, the station is automatically received.
• If the entered frequency is not in the receivable
frequency range, message "CAN NOT TUNE" is
displayed for 5 seconds, and the last station received
is received again.
■ Preset tuning
By storing the frequencies of broadcasting stations in the
preset channels according to the instructions in the "To
preset station frequencies" section, any of the preset
stations can be received by one-touch operation.
1. Press the preset function key to select "1 - 1 0 " or
"
1 1
-
2 0
" .
2. Press the numeric key corresponding to the preset
channel of the desired station.
• The display shows the frequency of that station, and
the station is received.
■ Preset Scan
This function allows the preset stations stored in the
preset channels to be received in sequence for 5 seconds
each.
1. Press the P.SCAN key.
• The frequency of each preset station is received for 5
seconds in sequence. A preset channel in which no
station has been preset is skipped, and the scan
operation moves to the next preset channel.
2. To stop Preset Scan, press the P.SCAN key again, '
• The preset station being received when the key is
pressed is received continuously.
■ To preset station frequencies
1. Press the band selector key for the desired band (FM or
AM).
2. Tune in the desired station following the instructions in
the "Tuning methods" section,
3. Press the preset function key to select the 1 - 1 0 o r
1 1 - 2 0 preset channel range,
4. Press the MEMORY key.
• The IMEMORYI indicator on the display lights.
5. Within 5 seconds after pressing the MEMORY key,
press the numeric key (1 to 0/1 0) corresponding to the
preset channel in which the frequency is to be stored.
• If a frequency has already been stored under the
selected preset channel, the previously-stored fre­
quency will be replaced by the new frequency.
6. Preset all desired frequencies by repeating steps 1 to 5
above.
• When preset channels 1 to 1 0 have become full,
press the preset function (1 - 1 0/1 1 - 20) key again
to select the 1 1 - 2 0 range.