RCA Flat Panel Television - Manual (Page 32)

Using tl#«í 'TV's Features
Digital or Analog TV Channels
A single off-air antenna can pick up both analog and digital channels. Digital t:hannels can be
made up of primary channels and sulachannels.
Note; Subchannels (sometitnes called rninor channels) are channels associated with the
primary channel (sonietimes called the rnajor cbannel). A primary channel may have just
one suhchannel or multiple suhchannels.
Tip:
Use the channel banner to determine whether
a channel is digital or analog. A digital (AT5C
or QAM) channel displays a "D" before the
channel and may have a dash and second
number after it (e.g., 21-1); an analog channel
(NTSC) displays an "A" before the channel and
only has one channel number (e.g., Ch 21).
IPGD 0
Direct Tuning to a Channel
1. Make stire the remote is in lA' mode by [rressing W on the remote control.
2. Enter the primaiy' channel number. This number appears in the primaiy' channel entiy box.
Press OK or wait a few seconds, If you doti’t enter a subchatinel, the dV tunes to the first
available analog channel or lowest digital subchannel,
3. If the prima.iy channel number has fewer thati six digits (for cable), or two digits (for
antenna) and you want to enter subchannel numbers, press the SUB CH or SUBCfiANNET
button to advance to the subchannel entiy box,
4. Enter the number of the subchannel. This number appears in the sulachannel entiy Itox,
3. Press C)K to tune to the channel or wait a few^ seconds and the lA' tunes to the channel
Note: You can always use the channel up and down buttons cm the remote control to
change channels within the IN tnode.
Getting a Program Description
f. Make sure the remote is in lA' mode by [sressing W on the remote control.
2. Press the INFO burton on the remote twice. If the information is available from the
broadcaster, a jarogram descrijation will appear.