RCA Flat Panel Television - Manual (Page 56)

liter liiif®irimati®ii
Lamp Replacement Information
Replacing the Lamp Unit
Your Ws source of light comes from a lam [5 — similar to lamj^s used in film or front projectoni. Althotigh this lamp is long-
lasting, it may need to be replaced eventually,
When to replace the lamp
You probably need a new lamja if there’s no pictrtre, but you still can hear the audio and the power light on the front of the
T\’ does the following: blinks 5 times, pauses, blinks 3 times again. If the 1Л' doesnt turn on after 5 minutes and then the
light blinks steadily for otie minute, the lamp may be dead, If you have atiy concerns, please contact us at 1-866-723-6486
or call an authorized seiwicer in ymir area.
Note: The same symptoms occur if the lamp unit isn't seated correctly or lamp access door is ajar If you
have recently accessed the lamp, make sure the lamp access door is completely closed and the lamp unit is
seated correctly.
Wliat to do
The lamp has been designed to make installation as easy as possible, but if you dont follow the direttions, there is a risk of
inju.
17 ,
• You can easily replace the lamp yourself by following the instructions that come pac:ked with the new lamp. If your 1Л-
is still covered by the warranty, call 1-866-723-6486 to receive troubleshooting assistance and a lamp replacement.
• If yoitr I '■ wau'ranty has expired, c:all 1-800-338-0376 to purchase a lamp replacement. If you are not comfoitable
.replacing the lamp yourself, call 1-866-723-6486 and we will refer you to a seivice person wcho will .replace the lamp for
you. There will be a service fee.
This .symbol indicates that the lamp in the НШЛ" contains mercuiT. Special disposal of the la nap for
environmental reasons may be required under the laws applicable to your jurisdiction. For disposal or recycling
information, please contact your loc:al authorities or the Electronic Industries Alliances www-,eiae.org or c:all
1-800-338-0376 for more derails.
What you’ll need to get started:
• To order the c:orrect lamp, you’ll need to know your lA’’s model number, serial number,
and lamp type—this information is listed on the Se:ivice Model Ytimber sticker (example
of the stic:ker is shown at le.ft). To locate the sticker, face the bac:k of the W. The sticker
is located, on the right side of the W (.see jricrtire below for sticker location).
•
• Follow the replacement instructions that come packed with the new lamp.
EXAMPLE: Service
Model Number
sticker with lamp
type listed.
Service Model Number
Sticker location with
Lamp Type