System option setting, Programming procedure – Toshiba TEC MA-315-100 User Manual
Page 110
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11069
22. System Option Setting
This chapter is provided for your selections of the register’s basic functions
according to the market and your requirements, some of which are already
indicated for reference in other chapters as to print/non-print items, key
functions, etc.
Programming Procedure
The System Options are divided into 16 addresses and each address is further divided into a
maximum of 8 bits (Bits 1 to 8). Each Address table is placed on the following pages.
Condition: After Daily Financial Reset
(refer to ‘'NOTE on Condition” on page 23)
Programming Procedure:
Use the MA Key to turn the Control Lock to "SET”
or the S Key to turn the Control Lock to "BLIND”.
“SET” status, enter “0” for the Address.
Examples) To SET Bit 2 only ................................................ Enter 2.
To SET Bits 2 and 3 .......................................... Enter 23.
To SET all the Bits............................................. Enterl 2345678.
To RESET all the Bits ....................................... Enter 0.
To change any Bit in an Address, enter the Address No. and enter all the SET Bit
Nos again. If a Bit No. is not included in the SET Bit Nos, the Bit will be RESET.
-108-