Toshiba TEC MA-315-100 - Manual (Page 25)

E01-11069
13. Tax Table Setting
For details about the actual tax table, contact to the location where the register
was purchased.
Setting the U.S. Tax Tables (also applicable to PST in Canada)
There are three ways to set state and local tax tables. Select one that suits
the tax table required to be set.
Condition for Setting: After Daily Financial Reset
NOTE on “Conof/t/on”;
Unless the register satisfies this condition, the programming operations will not be
allowed.
After ... Resef* means that the designated reset report must be taken before
entering the programming (setting) operation. An error will result if the operation is
attempted without taking the report.
However, it does not necessarily mean “immediately after ...” When the designated
reset report has already been taken and then some operations are performed in the
“X”, “Z”, or “SET'' mode, the condition “After ... Reset" is still satisfied and the
programming operation is still allowed.
On the contrary, when the designated reset report has been taken but then some
sales data relating to that report’s output data are entered in the “REG", “MGR”, or
“ El” mode, the programming operation will no longer be allowed and the same
reset report must be taken again.
Thus the condition “After ... Reset” indicates that alt the sales data relating to the
report data must be zero (except non-resettable memory data). Because of this
“Condition" requirement, the report data will be protected from any inconsistencies
of sales data entered in the period from a resetting of the report to another resetting
of the same report next time. When no condition is specified to a programming
(setting) operation, it means that the operation is allowed any time outside a sale but
the cashier must be signed off if the Cashier Signing Method is selected (See
Chapter 17.).
Setting Procedure:
Use the MA Key to turn the
Control Lock to “SET”.
X MGR
OFF
-T
^
V
Z
SET
—► Go to 1), 2), or 3) on the following pages.
Indications of types of keys on the following pages:
□ Individual Numeric Key
I______ I ....... Data to be entered through Numeric Keys
...... Function Key
- 2 3 -