Toshiba D-VR610KU - Manual (Page 12)

O V i í l -
Remote Control
Installing the Batteries in the Remote Using a Remote Control
Install the batteries (AAx2) matching the polarity
indicated inside battery compartment of the remote
control.
1
Open the cover.
2 Insert batteries.
3
Make sure to match + and - on the batteries to
the marks indicated in the battery compartment.
Close the cover. * •
I Never throw batteries Into a fire.
Be sure to use AA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the
environment in mind. Always dispose of batteries in
accordance with applicable laws and regulations.
• If the remote control does not operate correctly, or If
the operating range becomes reduced, replace
batteries with new ones.
» When necessary to replace batteries in the remote
control, always replace both batteries with new ones.
Never mix battery types or use new and used
batteries in combination.
► Always remove batteries from remote control if they
aíre dead or if the remote control is not to be used for
an extended period of time. This will prevent battery
acid from leaking into the battery compartment.
Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the remote
control and the infrared sensor window on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the infrared
sensor window of the unit.
• Remote control for different devices can interfere with
each other. Avoid using remote control for other device
located close to the unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote control.
• The maximum operable ranges from the unit are as
follows.
- Line of sight: approx. 23 feet (7m)
- Either side of the center:
approx. 23 feet (7m) within 30°
^-------------
““II -
-------
M«™
_ ______
-- H-J
23feet (7m)
30” 30”
23feet (7m) 23feet (7m)
12 EN