Toshiba TEC MA-1100-100 SERIES User Manual
Page 107
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONDITION: After Auto Reset and GT Reset
OPERATION: Mode Lock: SET
TAX TABLE PROGRAMMING
1) Tax 1 Full Breaks
I
max. amount non-taxable| ITXl/Ml
I
max, amount for
tax levied! ^ ITXl/Ml
I
max, amount for
tax levied
1
-> [ TXlTt^l
Repeat until the "A" Break is enterd.
I
max, amount for N)zf tax levied
I I
TXl/Ml ... "A" Break
I
ST 1 (to indicate the "A” Break entry)
¡max, amount for N+l);? tax levied! -> ITXl/
m
1
Imax. amount for N+2)i( tax levied
1
-»
I
TXl/Ml
Repeat until the "B" Break is entered.
1AT/TLI (to end)
NOTE: The amount entry may be a maximum of 4-digit value (9999/)*
2) Tax 1 ”A” Break and
%
Rate Combination
First set the "A" Brealc following the same operation up to the "A"
Break entry and the
I
ST | depression in the above "1) Tax 1 Full
Breaks".
I
TAX RATE applied when exceeding the "A" Break amount{
(Maximum 4 digits, up to 99.99^* Do not use the [7] key. Example:
To
set
5^,
enter
500.
The
fraction
of
the
amount
resulting
from
this
%
rate calculation will be rounded off.)
IAT/TLI (to end)
3) Tax 1
%
Rate Only
10| -> |TX/M| -> [ST] [TAX RATE
I
I
AT/TL
I
1
(The conditions of the rate are the same as
the above TAX RATE.)
103 -