Toshiba TEC MA-1100-100 SERIES - Manual (Page 133)

REPLENISHING THE STORE NAME STAMP WITH INK
Fig. 20
Ink Bottle
When the store name stamp is printed too
lightly, replenish the ink in the following
manner.
1. Turn the Power Switch to OFF.
2. Remove the Ribbon Cover (Fig. 14).
3. Open the Cutter Block (Fig.15 and Fig.16).
4. Draw out the store name stamp in the
direction shown in Fig.20 with the
protruding part pinched with your fingers
(Fig. 20).
5. Apply ink on the pad on the rear side of
the Store Name Stamp. The amount of the
refiling should be adjusted according to
the density of the printed message, but
the limit of 2 c.c. should not be exceeded.
(The ink bottle suppled contains 5 c.c.
of ink.) (Fig. 21)
NOTES: 1) Replenish the ink drop by drop
several times until the pad will
not absorb any more.
2) Use the TEC genuine ink for
replenishment.
6. Re-assembly is the reverse procedure.
(Fig. 22) Let Point ”B" of the Stamp fit
to Point "A" of the Stamp Holder, push
the stamp all the way in until a "click"
is heard.
7. Close the Cutter Block.
8. Turn the Power Switch to ON.
9.
Depress the key. The flashing display
will stop and be lit steadily,
10. Depress the [NS I key to issue a receipt.
Repeat this to check if the printout will
turn out all right.
11. Attach the Ribbon Cover.
- 129 -