Toshiba TEC MA-1100-100 SERIES - Manual (Page 81)

DEPARTMENT NAME AND STATUS PROGRAMMING OR CHANGING
CONDITION: To change the Department Name only: Any time outside a sale
To change the Department Tax Status: After Auto Reset
To change the Department Positive/Negative Status:
After an Auto Reset,
GT Reset, and PLU Reset
OPERATION: Mode Lock: SET
3l I®/ for I -
(or (T| ) I
(EEZEI)
L
for tax status
change in single­
tax area
-►( IfXl/Ml ) { ITX2/MI )■»
for tax 1 for Tax 2
status status
change change
- » ( f s i T M l ) -
for S.I.
status
change
►( IRTN MDSE1 )-
for negative/
positive status
change
in dual-tax area
----------- STEP (A): Status Change
f
{I SHIFT I) for shifted
I Departments only
Department
Repeat for the next character,
regular-sized
‘
character
Character Codei*>
(2 or 3 digits^
see the table
-------1@/ for |
on page 113,)
one double-sized
character
l@/FORll@/FORl
for spacing instead
of a character
Entire name with
all double-rrsiffied
characters
at / tl I
to end the DP Name
(If any space is
left unprogrammed
in the tail, it
will automatically
be programmed as
space.)
k STEP (B): Name Change
NOTES: 1. The " 1 Department 1" is the Department Key whose status or name
should be changed or programmed in this operation. The I SHIFT I
and
I
Department
|
depressions will result in operating the shifted
department. For example, I SHIFT I and I Dept. ll will be I Dept. ifl .
I?1 key after the Character Code entry may be replaced by
the l#/CID I or I j^/NS I key.
3. For the name of a department, a maximum of 8 regular-sized
characters or 4 double-sized characters may be entered, A combi­
nation of both types is also available.
- 7 7 -