Toshiba TEC MA-1100-100 SERIES User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLERK LOCKS
Lock-and-Key Type (Standard)
These
locks
are
used
to
identify
which clerk is operating the register.
Clerk Keys (CLl, CL2, CL3, CL4)
Each
clerk
should
keep
his/her
clerk
key.
The
register
will
not
operate
unless
one
of
these
keys
is
inserted
and
set
to
the
corresponding
position
on the Clerk Locks. Each of the keys may be inserted
and
pulled
out
in
the
neutral
position
marked
with
the (point).
Push-key Type (Alternative Option, for ten clerks)
Ll I 2 I 3 I 4 I 5 I
I 6 I 7 I 6 I 9 I 10 I
This
type
may
be
installed
in
place
of
the
Clerk
Locks
above,
as
an
alternative
option.
In
that
case,
ten
clerk
keys
will
be
installed.
Each
clerk
is
assigned
to
his/her
own.
clerk
key
(1
through
10).
The
register
will
not
operate
unless
one
of these keys is pushed to stay down.
GT LOCK
G T X
This lock is provided to read or reset the accumulated
sales totals not on the daily but on weekly or monthly
basis.
GTX Position:
This
position
allows
to
read
the
accumulated totals.
The GTX key as well as GTZ Key can
access this position.
GTZ Position:
This position allows to read and reset
the accumulated totals.
The GTZ Key
position.
only can access this
NOTE: When the GT Lock is turned to either the
GTX or GTZ position, the Mode Lock position
or
any
Clerk
Key
ON/OFF
condition
will
be disregarded.
- 3 -