Toshiba TEC MA-1100-100 SERIES - Manual (Page 131)

INSTALLING THE JOURNAL PAPER
1. Turn the Mode Lock to the "REG” position.
2. Remove the Receipt Cover by pulling it
upward (Fig. 1 on the previous page).
3. Remove the Journal Winding Reel.
4. Set the new paper roll in the journal roll
holder (righthand side) with the paper
end from the bottom (Fig. 7),
5. Insert the paper end into the journal
inlet while holding the | JF1 key pushed
down (Fig. 8).
6. When the paper comes out of the journal
outlet for approx 20cm (or 8 inches),
release the [JF| key (Fig. 9).
7. Wind up the paper end on the Journal Wind­
ing Reel two or three times as shown in
Fig. 10.
8. Set the Journal Winding Reel to the holder
(Fig. 11).
9. Attach the Receipt Cover (Fig. 12).
10. Depress key before starting operations.
REMOVING THE JOURNAL PAPER
1. Remove the Receipt Cover by pulling it
upward (Fig. 1 on the previous page).
2. Depress |JF| key to wind up enough portion
of the journal paper, and then tear off
the paper, holding the Journal Winding
Shaft.
3. The wound-up portion of the paper can
easily be removed from the Winding Shaft
by pulling it side way (Fig. 13).
4. If enough paper remains on the roll,
follow Steps 6 through 10; if paper is
running
out, follow Steps 1 through 10
in "INSTALLING THE JOURNAL PAPER" above.
Fig. 10
- 127 -