Toshiba TEC MA-1100-100 SERIES - Manual (Page 77)

ADDRESS NO.
11
CONTENTS
SELECTIVE ITEMIZER CONTROL
BIT
NO.
ITEM SELECTIVE STATUS
STANDARD
STATUS
REMARKS
1
D
Sl/TL Print
RESET PRINT
—on Receipt and Remote Slip
-(but prints on Journal only) SET NON-PRINT * —
2
%I/TL Compulsory
Before Finalizing
each Sale
RESET FREE *
SET COMPULSORY
3
B
SI/TL %- Affect
Main Itemizer
RESET IGNORE *
SET AFFECT
4
B
SI/TL %+ Affect
Main Itemizer
RESET IGNORE *
SET AFFECT
5 —vacant—
RESET
SET
6 —vacant—
RESET
SET
7 —vacant—
RESET
SET
e —vacant—
RESET
SET
Standard Bit Set
1 I I I I I I I *
NOTES D: When either Bit No.3 or No.í^ is selected to the "SET" status, the S.I. total amount will
be printed on receipt regardless of the Bit No.l status selection.
B; If status "SET" (COMPULSORY) is selected, depression of the ISI/TLI key is compulsory
before finalizing a sale that contains any item with the S.I. status. Otherwise, it will
result in an error.
B C B: If, for example, 5^ has been preset for the Sl/TL % and the "SET" (AFFECT) is selected
for Bit No.3, the amount calculated out as 5^ of the S.I. total amount will auto­
matically be printed and subtracted from the main itemizer.
* Status Selection Combinations:
Bit No.3 ... RESET — p ~SI/TL operation will not affect the main itemizer
RESET at all.
SET —jj-Will result in the same condition as only the "SET"
SET —^ status of Bit No.A is selected (i.e., AFFECT by preset
%+ rate.)
Bit No.4
Bit No.3
Bit No.4
* If no preset % rate is programmed but either of Bit No.3 or No.4 is set to "SET"
( affect ) status, the calculation will result on the basis of the rate of 100%.
- 73 -