Toshiba TEC MA-1100-100 SERIES - Manual (Page 33)

PRESET PLU code ! ^ IIC/VD
OPEN PLU code ! I IC/VD I -
'PLUl
PRICE TO BE voided !
Imi
NOTES: 1. Designated voiding cannot be made on a department that has
been preset as a negative department.
2. Unless the "Credit Balance" option has been selected, voiding
to result the sale total into negative will go into an error.
3. The I IC/VD I will function the same as the I VOID I key except
that: _____
1) iVOIDI may be depressed before or after a numeric entry,
if before the motorized key (key to cause the line item
print).
2) IIC/VDI can only be depressed after a numeric entry. If
depressed at the top, it will item-correct the last item
just entered before the IIC/VDi depression. Therefore,
in voiding a preset department entry, the quantity must
be entered first (if a normal entry, the quantity will be
"1"), next depress I IC/VD1. and then I PRESET DEPT I .
NON-ADD NUMBER PRINT (Mode Lock: REG, MGR, or 0)
I NUMBER I in (or f#7t^i > -►-------------
L.(Cheque No., Customer No., Credit Card No., etc.; max. 8 digits)
NOTES: 1. If the "Non-add Number Print Allowed Only Once" option has
been seleceted, a second non-add number entry in a sale will
result in an error,
2. The [T] key cannot be used to enter a non-add number.
SELECTIVE ITEMIZED (S.I.) STATUS MODIFICATION (Mode Lock: REG, MGR, or 0)
fsiTMl PRESET DEPT ->--------
ISI/MI ^ I PRICE I ^ I OPEN DEPTl -----------
ISI/MI I PRESET PLU CODEl fPLUl -►------------------
iSI/Ml ^ I OPEN PLU CODEl h . [PUTI ^ jPRICEl AMT
NOTE: If the department or PLU has been programmed with the S.I. status,
it will be reversed to non-S.I. status. If it has been programmed
with non-S.I. status, it will be reversed to the S.I. status by
the depression of the 1SI/M| key.
SELECTIVE ITEMIZER (S.I.) READ (Mode Lock: REG, MGR, or 0)
Dept, or PLU entries ... SI/TL| -► ------- The selective itemizer total
is displayed and printed on
the receipt.
- 29 -