Cisco 4400G - Manual (Page 11)

11
• If you will connect your DMP to an analog display,
do all of the following:
– Plug one yellow jack on the RCA video cable
into the CVBS interface on your DMP.
– Plug the 3mm jack on the RCA audio cable
into the AUDIO interface on your DMP.
Step 2 Connect the other end of the cable (or cables) to the
corresponding interface (or interfaces) on your
DMP display.
Step 3 If the DMP display is not already turned on, turn it
on now.
5
Connecting to a 100V–240V
AC Socket
Warning Use only the supplied power cable and adapter.
Step 1 Connect the DMP power cable to the AC adapter.
Step 2 Connect the DC barrel connector to the 12V DC power
supply on the DMP chassis.