Comtrol RocketPort Windows 98 - Manual (Page 17)

Installing the New Driver 17
Windows 95/98
If the All box is checked, all ports after the one you select are
automatically numbered in sequence:
You can also use the New Description field to rename individual
ports: for example, you can describe COM5 as RocketPort 1.
14. If desired, click the Advanced button to access the Advanced Board
Options window.
For example, the Advanced Board Options are used to configure
the driver for rates above 230.4K bps. For more information, see
Advanced Board Options, beginning on page 22.
15. When you are done, click OK to exit the Board Options window.
16. Click OK to exit the System Properties window.
17. Reboot the system so that your changes take effect.
18. If you have installed a RocketModem, go to page 27.
To configure all other modems, go to page 29.
To configure serial printers, go to page 31.
Software Installation: ISA-Bus
Follow these steps to install the Windows 95/98 device driver for use
with an ISA-bus RocketPort or RocketModem:
1. If you are updating from an earlier version of the Windows 95/98
driver, install the hardware, use the driver update process
described on page 12, then update the configuration as needed.
If you are upgrading from the Windows 3.1 or Windows for
Workgroups driver, remove the old software before proceeding. If
you need help doing so, contact Comtrol technical support.
2. Click the Start button, select Settings, then select Control Panel.