Comtrol RocketPort Windows 98 - Manual (Page 22)

22 Advanced Configuration
Windows 95/98
15. Your system is now ready for use. No reboot is necessary.
16. If desired, continue with the Advanced Configuration options, below.
To configure external modems, go to page 29.
To configure serial printers, go to page 31.
Advanced Configuration
After initial installation, use the following procedures to change
RocketPort/RocketModem configuration settings.
COM Port Numbering
When installing a PCI-bus RocketPort, the COM port numbers are
usually set in Step 13 of the PCI installation procedure. When
installing an ISA-bus RocketPort or RocketModem, the first Comtrol
port defaults to COM5 and the other ports follow in sequence.
To change the COM port number assignment, follow these steps:
1. Access the System Properties window. (Either double-click on the
Control Panel System icon or right-click on the My Computer icon
and select Properties.)
2. Select the Device Manager tab.
3. Double-click on Multi-function adapters.
4. Select the RocketPort/RocketModem and click Properties.
5. Select the Board Options tab.