Comtrol RocketPort Windows 98 - Manual (Page 7)

Overview 7
Introduction
Overview
The Comtrol RocketPort/RocketModem Software Installation and
Configuration Guide covers the following Comtrol software products:
• RocketPort/RocketModem Windows NT Driver (6540)
• RocketPort/RocketModem Windows 95/98 Driver (6533)
• RocketPort/RocketModem Novell NetWare Driver (6535)
• RocketPort/RocketModem SCO OpenServer Driver (6543)
• RocketModem AT Command Set
Please note that these software drivers support a broad range of
Comtrol hardware products, and that both this guide and the driver
you install may include features not applicable to your installation.
Each Comtrol adapter, board, or interface comes packaged with a
Hardware Reference Card, which covers hardware-specific installation
instructions and performance characteristics. For more information
about your Comtrol product, see the Hardware Reference Card.
Operating System Requirements
The drivers discussed in this document work with the following
operating systems:
• Microsoft Windows
®
NT (3.51, 4.0, or higher)
Note: NT 4.0 or higher is required to support Multilink PPP.
RAS or RRAS is required to support Remote Access Service.
Under NT 4.0, Service Pack 3 is required to support RAS.
• Citrix
®
WinFrame
®
(1.7 or later)
• Microsoft Windows
®
95 and Windows
®
98
• Novell
®
NetWare
®
3.12, 3.2, or 4.1x (with MPR 3.1A or higher and/
or NetWare Connect 2.0.30 or higher)
• Novell IntranetWare I (with NIAS and Support Pack v1.0)
• SCO
®
OpenServer
™
(5.0.x)